Many kinds of carpet, if the carpet below the surface layer and the bottom itself is heavy, not easy to be kicked up, and used in family activities less room, around the room with furniture, can play a fixed role of the carpet, can adopt the movable type pavement simple method. Specific practices are as follows:
According to the size of the room, in the store to buy a carpet, it is necessary to cut the size of the length of the pavement by the door to the door gradually pushed. If the width of the carpet is not consistent with the width of the room, the width of the carpet should be on the back of the width, with a sharp knife cut along the line. Two pieces of carpet to the junction of stitching, in on the carpet back with a thick needle sewing, painted carpet glue in both sides and butt seam tape, the tape on the carpet seam seam, then the carpet is over, with the flat shovel around the corner, the carpet trim is flattened, placed on the furniture.
A barbed roll of carpet paving board
A barbed board paving carpet is the most basic method of carpet, carpet is also the most application method, the roll is provided with the elastic rubber pad for carpet carpet beneath the individual shop. Specific methods and procedures are as follows:
The room is clean, with high strength cement nails barbed nails in the floor board in the room around the edge along the skirting board, cement nail spacing less than 400 mm, barb card distance mopboard 8~10 mm, oblique barbed nail should be toward the wall. The pavement elastic rubber pad, rubber pad should leave a barbed board covered with 10 mm, take the sticky, first along the long side paved pad side, and then lay down on the other side, the amount of size, away from the other side of the pull 10 mm, elastic line cut, with 107 dots stick to the base on the ground.
The carpet in the store to buy when they have been cut, will be justified after stitching needle, stitching the seams brush latex 50~60 mm wide, with a cloth or affixed with plastic tape affixed to the seam. Will have sewed up the carpet tile, a long side carpet first fixed in the pull, the border edges all buried in the skirting board or with skirting board tightly compacted, and then fixed to the side to side by push, repeated several times leveled, which is fixed on the other side of the barbed on the board, with the knife to cut the excess, will cover flash press on a skirting board, use the same method of fixing the rest on both sides.
Not a place at the door of barbed board, application of closure strip of carpet compaction. Finally, vacuum cleaner to clean up the installation process, so that the carpet surface of Shunping.
Adhesive fixed pavement of rolling carpet
If the carpet is thin, it is easy to uplift in the walk, neither beautiful nor safe, for a long time the carpet will be deformed, dressing is very troublesome, must therefore take the pavement bonding methods of fixed, specific steps are as follows:
If the activities of the family frequently, furniture and less room to lay the carpet, you should use the full brush glue. The carpet shop in the room, the size of the room to be consistent with the same method with other paving methods. The carpet will be rolled up more than 1/2 in the middle ground, brush a carpet glue, drying after 5~10 minutes, will be on the carpet, firm bonding, roll up side, on the ground after the carpet brush glue, and then use the same method of paving the other half. Paving carpet, carpet must be leveled, paving after flattening and compacting, surrounding the excess, with a knife cut after flattening.
If the room does not often walk around, there are more furniture placed, you can use the local brush glue bonding method. The first test in the room after the carpet rolled up, 1/2, in the middle ground brush carpet glue, dry after paving, and then along the wall brush two strips of adhesive tape, carpet paving, placed furniture, furniture on the carpet.
